SPI Products Areas of Benefit for Maritime Applications

SUPER THERM®

  • Wheel houses - Top decking to prevent heat buildup and conduction into holes.
  • Equipment and electronics on deck that need protection from heat.
  • Application of SUPER THERM® blocks sound by up to 68% through hulls, walls, etc.
  • Application of SUPER THERM® resists the growth of mold and mildew.
  • Prevents the occurrence of condensation when applied to dry clean surfaces.
  • DNV approved.

RUST GRIP®

  • Prime entire hull – below and above water-line.77
  • All metal on ship – interior and exterior.
  • Helps to prevent concrete from spaulding.
  • Can be applied with minimum prep and hand tooling.
  • Remove embedded salt deposits with wire brush or brush blast and a solvent wash.
  • Lay non-skid material down between two layers of the coating for an extremely
  • durable footing - catwalks, decking, hallways, etc.
  • DNV approved.

ENAMO GRIP

  • Top coat in colors for above water-line.
  • Can be used in white to top coat over SUPER THERM® to provide better weathering
  • in ocean environment.
  • Used on interior for color or clear.
  • Used on flooring in grey or clear with non-skid.

MOIST METAL GRIP

  • Apply over RUST GRIP® on the exterior of the hull below the water line.
  • Coat directly over wet or moist pipes on interior to control condensation and
  • corrosion.
  • Apply directly over wet surfaces - Drys chemically.
  • Apply directly over interior of hull over wet or moist surfaces to prevent and
  • encapsulate rust deposits.

EPOXOTHERM

  • Apply over Moist Metal Grip on the interior of hull below water line to control
  • condensation.
  • Apply over coolers and cold substrates to prevent condensation on surfaces and
  • improve efficiency of unit.
  • If A/C ducting is condensating and wet, apply directly over the wet surfaces to stop
  • and prevent the condensation.

OMEGA FIRE

  • Apply on interior of engine rooms to prevent spread of fires.
  • Apply on interior of holes between compartment walls to prevent spread of fire.
  • Apply over all sensitive electrical and control boxes to protect from fire.
  • Apply on walls of sleep quarters and wheel houses.
  • Apply on interior walls of kitchen area and boiler rooms.
  • Tested for the U.S. Navy Carrier Group.
  • DNV approval pending.

HPC™ HOT PIPE COATING

  • Apply directly to surface of hot pipes and boilers during normal operation for
  • insulation and protection.
  • Encapsulates hot surfaces to control corrosion.
  • Provides protective covering for hot surfaces and reduces exterior temperatures for a safer working environment.

HSC™ 300 HOT SURFACE COATING

  • HSC™ Coating is designed to control hot surface temperatures ranging between
  • 150-350 F. degrees (240C).

LINING KOTE

  • Apply inside of acid or caustic tanks or drip areas to prevent corrosion and
  • deterioration.

10511A Windsor Lane., Suite 103 · Houston, Texas 77031
(281) 561-7432

Copyright © 2009-2010 Coatings Solutions · All Rights Reserved